Siemens Sinumerik 840D Operating Turning page 360

Section 2
Notes
B526
B526
Selection and function of the operating area "Diagnostics"
By pressing the HSK 8 "Version" also software
components with their version information will be
displayed.
This function is described in the commissioning
manual of the Sinumerik Operate.
2.3 Horizontal softkey bar 2
Display area Description
By pressing the HSK 2.1 "BUS TCP/IP" in the ex-
tended horizontal softkey bar, the profibus status
for diagnostic purposes during the configuration or
when errors occur will be displayed.
Note:
This function is described in the commissioning
manual of the Sinumerik Operate.
By pressing the HSK 2.2 "Axis diag." in the ex-
tended horizontal softkey bar the "Service over-
view"-window opens.
This function is described in the commissioning
manual of the Sinumerik Operate.
By pressing the HSK 2.3 "SI diag." in the extended
horizontal softkey bar the "Safetey integrated
status"-window opens.
Note:
This function is described in the commissioning
manual of the Sinumerik Operate.
By pressing the HSK 2.7 "System utiliz." in the ex-
tended horizontal softkey bar, the "System utiliza-
tion"-window opens where the system resources for
the NC areas are shown.
This function is described in the commissioning
manual of the Sinumerik Operate.
By pressing the HSK 2.8 "Drive system" in the ex-
tended horizontal softkey bar the "Overview for the
drive states"-window opens.
Note:
This function is described in the commissioning
manual of the Sinumerik Operate.
Page 4 840D/828D SINUMERIK Operate