Siemens Sinumerik 840D Operating Turning page 629

Complex programming example
43. Fill out the parameter mask as follows:
In order to insert a tool into the parameter mask,
press the VSK 1 "Select tool", mark the appropriate
tool (ROUGHING_TOOL_A80) with the orange se-
lection cursor and press the VSK 1 "To program".
Accept your selection by pressing the VSK 8
"Accept".
The program block "Residual cutting" will be inserted
into the work plan:
The program chain is extended.
44. As a last machining step, program a "Stock removal"
cycle.
Press the VSK 1.2 "Stock removal" to open the pa-
rameter mask for the "Stock removal" cycle.
45. Fill out the parameter mask as follows:
840D/828D SINUMERIK Operate
Section 3
Notes