Siemens Sinumerik 840D Operating Turning page 445

Complex programming example
Press the VSK 2 "Contour call" to open the input
mask for the call up of the contour.
9. Insert the following contour name into the parameter
mask:
Confirm your input by pressing the VSK 8 "Accept".
The following line will inserted into the program:
N170 CYCLE62("SPIGOT_FINISHED",1,,)
Note:
The contour "SPIGOT_FINISHED" you called up
here, will be created in section 52.
10. Insert now a stock removal cycle "CYCLE952" into
the program.
Press the VSK 2 "Stock removal" to open the pa-
rameter window for the stock removal cycle.
The following parameter mask for the "CYCLE952"
opens.
11. Fill out the parameter mask as follows:
Confirm your inputs by pressing the VSK 8 "Accept".
840D/828D SINUMERIK Operate
Section 3
Notes