Siemens Sinumerik 840D Operating Turning page 287

Tool list
3.9 Delete tool
To keep the tool list short and clear, unused tools can be deleted from the
tool list.
3.9.1 Selecting the function "Delete tool"
Pressing the VSK 1.6 "Delete tool" the "Delete tool"
dialogue window opens.
3.9.2 Deleting a tool
1. Either press the "OFFSET"-key on the keyboard or
press "MENU SELECT" on the operator panel, then
the HSK 2 "Parameter" and the HSK 1 "Tool list" to
switch to the tool list.
2. In the tool list window place the cursor on the tool
that you would like to delete.
Press the VSK 1.6 "Delete tool".
A safety prompt is displayed asking for confirmation.
3. Press the VSK 8 "OK" to delete tho tool or press the
VSK 7 "Cancel" to abort.
The tool is deleted from the tool list.
If the tool is in a magazine location, it is unloaded
and then deleted.
Several load points
If you have configured several loading points for a magazine, then the
"Select loading point" window appears after pressing the VSK 6 "Delete
tool".
Select the required load point and press the VSK 8 "OK" to unload and de-
lete the tool.
840D/828D SINUMERIK Operate
Section 3
Notes