Siemens Sinumerik 840D Operating Turning page 619

Section 3
Complex programming example
Notes
3.1 Example: Spigot
The following program is to be created, with the call up of the contour de-
scriptions, as well as stock removal- and the residual cutting cycles.
Create a new ShopTurn sequential program like described in section 2.1 in
this module.
Name the program "ST_CONTOURTURNING_2.MPF".
The program, with the parameter mask for the program header
opens by default.
1. Program the program header like displayed below:
840D/828D SINUMERIK Operate