Siemens Sinumerik 840D Operating Turning page 604

Hide thumbs Also See for Sinumerik 840D:

Complex programming example

Press the VSK 4 "Groove 2", to open the parameter

mask for the cycle "Groove 2".

Insert the following values into the parameter mask:

To insert a tool into the parameter window, press the

VSK 1 "Select tool".

Mark the desired tool (here PLUNGECUTTER_3) in

the tool list with the orange selection cursor and

press the VSK 1 "To program".

Confirm your inputs by pressing the VSK 8 "Accept".

The following programm block is inserted into the

Insert now an undercut cycle into the program.

Press the VSK 3 "Undercut".

The work area for the technology "Undercut" opens.

Press the VSK 5 "Undercut thrd DIN" to open the

parameter mask for the undercut cycle "Undercut

thread (DIN76)".

Insert the following values into the parameter mask:

840D/828D SINUMERIK Operate

Sinumerik 828d