Installing The New Riser Card; Connecting Cables To The Expansion Card - Fujitsu PRIMERGY RX2540 M1 Upgrade And Maintenance Manual

Figure 112: Removing a riser card
Ê Remove four screws (see circles).
Ê Take the riser card out of the riser card holder.
9.5.6.3

Installing the new riser card

Ê Install the new riser card as described in section
on page 187.
Ê Install the expansion card as described in section
card in a riser module (HL)" on page
Ê If applicable, install the riser module 1 as described in section
riser module 1 (HL)" on page
Ê If applicable, install the riser module 2 as described in section
riser module 2 (HL)" on page
9.5.6.4

Connecting cables to the expansion card

Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
cables" on page
RX2540 M1
190.
200.
411.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Installing a riser card (HL)"
"Installing an expansion
187.
"Installing the
"Installing the
"List of used
209