Sas Expander Board; Installing The Sas Expander Board - Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual

Hard disk drive (HDD) / solid state disk (SSD)
CAUTION
Incorrect cabling may cause wrong LED identification of the HDD/SSD.
Misleading LED could lead to swapping out the wrong HDD/SSD, and
that will result in data loss.
▶
Check the correct cabling using the labels on the cables and the
cable plans.
Concluding steps
▶
"Installing the fan cage" on page
▶
"Reassembling" on page
▶ Insert all PCIe SSD modules, see
on page 179.
Ensure that you install the PCIe SSD module in the bay it was located
before the HDD backplane replacement.
▶ Insert all dummy modules, see
module" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ Verify that the iRMC S6 recognizes the installed HDDs/SSDs.
▶ If applicable,
"Installing the front cover with lock" on page
7.7

SAS expander board

7.7.1

Installing the SAS expander board

The SAS expander board is an option for the 12x 3.5-inch HDD
configuration, the 16x 2.5-inch HDD/SSD configuration and the 24x 2.5-
inch HDD/SSD configuration.
202
77.
59.
"Installing a 2.5-inch HDD/SSD module"
"Installing a 2.5-inch HDD/SSD dummy
182.
71.
Upgrade and Maintenance Manual
65.
71.
RX2540 M7