Protective Covers; Open-Chassis Type - YASKAWA V1000 Series Installation & Start-Up Manual

3.5 Protective Covers

3.5 Protective Covers
Follow the procedure below to remove the protective covers before wiring the drive
and to reattach the covers after wiring is complete.
◆

Open-Chassis Type

Removing the Protective Covers
■
1.
Loosen the screw that locks the front cover in place to remove the front
cover.
Figure 3.8
Figure 3.8 Remove the Front Cover on an Open-Chassis Drive
2.
Apply pressure to the tabs on each side of the terminal cover. Pull the
terminal cover away from the drive while pushing in on the tabs to pull the
cover free.
Figure 3.9
Figure 3.9 Remove the Terminal Cover on an Open-Chassis Drive
64
YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)