Led Screen Displays; Lo/Re Led And Run Led Indications - YASKAWA V1000 Series Installation & Start-Up Manual

◆

LED Screen Displays

Display
When the drive detects a alarm
or error
Motor is rotating in reverse
REV
Drive Mode
Displays output frequency (Hz)
As
illustrated in
this manual
◆

LO/RE LED and RUN LED Indications

LED Lit
The run command
and frequency
reference source is
assigned to the
LED operator
(LOCAL)
During run
As shown
YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)
Lit
• When an alarm occurs
• OPE detected
• When a fault or error occurs
during Auto-Tuning
Flashing
—
• Run command from external
source is active during power-
• During
up and b1-17 = 0 (default)
deceleration to
• Drive disabled (digital input set
stop or when a
to H1-
run command is
off)
input and the
• Motor stopped by Fast-Stop
frequency
input (LED flashes until Fast-
reference is 0
Stop input and RUN command
are off).
4.2 Using the Digital LED Operator
Flashing
Normal state (no fault or alarm)
— Motor is rotating forward
— Programming Mode
—
Flashing Quickly
—
= 6A and input is
Off
—
Off
Drive requires an external
source to provide the run
command, such as a control
circuit terminal,
MEMOBUS/Modbus
communications, or option
card. (REMOTE)
During stop
105
4