YASKAWA V1000 Series Installation & Start-Up Manual page 369

No.
Multi-Function Digital Input Terminal
H1-05
S5 Function Selection
Multi-Function Digital Input Terminal
H1-06
S6 Function Selection
Multi-Function Digital Input Terminal
H1-07
S7 Function Selection
<18> Parenthetical value is the default when parameter A1-03 = 3330 3-Wire Initialization.
H1-
Function
Setting
0 3-Wire Sequence
1 Local/Remote Selection
2 Option/Drive Selection
3 Multi-Step Speed Reference 1
4 Multi-Step Speed Reference 2
5 Multi-Step Speed Reference 3
6 Jog Reference Selection
7 Accel/Decel Time 1
8 Baseblock Command (N.O.)
YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)
Name
Refer to H1-01
H1 Multi-Function Digital Input Selections
Closed: Forward and reverse run commands are set up as
a 3-wire sequence.
The run and stop commands are automatically assigned
to terminals S1 and S2.
Opening and closing the terminal causes the run
command to switch between the digital operator and a
remote source.
Open: Local
Closed: Remote
Closed: Option card
When terminal A2 is set for auxiliary speed reference
signal of 0 to +10 V (H3-09 = 0), the values set to d1-01
through d1-16 can be selected using a combination of
Multi-Step Speed Reference Step 1 through 4.
Closed: Inputs the Jog Frequency reference (d1-17).
Takes priority over other multi-step speed references
1 through 16
Switch between parameters C1-01 through C1-04 based
on Accel/Decel Time Selection 1. Switching is also
possible between C1-05 through C1-08 by combining
this function with Accel/Decel Time Selection 2 (1A).
Open: Normal operation
Closed: No drive output
B.2 Parameter Table
Description Range Def.
0 to 9F
0 to 9F
0 to 9F
Description
Control
Mode
Addr. Pg.
O
V/ P
Hex
L
f M
V
3(0)
A A A 402 —
<18
>
4(3)
A A A 403 —
<18
>
6(4)
A A A 404 —
<18
>
Control
Mode
Pg.
V/ O P
f LV M
O O O —
O O O —
O O O —
O O O —
O O O —
O O O —
O O O —
O O O —
O O O —
369
B