YASKAWA V1000 Series Installation & Start-Up Manual page 321

Outputs-Digital
Output-Digital Pulse Train
Frequency Setting
Power Supply
Quick Disconnect Terminals
Removable Control Circuit
Terminal Board
Control Power Supply
DC Bus Charge Indicator
Cooling Fin Overheat
Protection
Heat Sink Temperature
Inertia Ride-Thru Function
Instantaneous Over Current
Trip Level
YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)
Item
Quantity
Signal Level Type
Programmable Functions
Quantity
Signal Level
Frequency Range
Programmable Functions
~
Type
~
~
~
~
Monitor
~
Cooling Method
Fault Method
~
%
A.3 Common Drive Specifications
Specification
3
Qty. 2 Photo-Coupler Output:
DC 48 V 50 mA or less
Qty. 1 (fixed/fault): Form C, 250 Vac, 1 A or
less, 30 Vdc, 1 A or less
Yes
1
Sourcing: Output volts and load impedance
+5 V at >1.5 kOhm, +8 V at >3.5 kOhm,
+10 V at >10 kOhm
Sinking: External power supply +15 Vdc +/-
10%, sinking current 16 mA or less
0-33 kHz
Yes
+10 V allowable max current 20 mA
Yes, remove I/O via removable terminal
board
Yes
Separate input for 24 Vdc control power
supply (option)
Dedicated charge lamp LED stays on until
bus is < 50 Vdc
Protects IGBTs by detecting heatsink
overheat due to a fan fault or temperature
increase. ("fan-lock" sensor)
Yes, Detects heatsink temperature and issues
a pre-alarm
Yes,
Overheat Prevention
(frequency reduction method)
Single phase 200 V class: cooling fan for
BA0010 - 0020
Three phase 200 V class: cooling fan for
2A0006 to 2A0020
Three phase 400 V class: cooling fan for
4A0005 to 4A0011
Smaller drives are self-cooled
Pre-alarm, Coast, Ramp, Continue
Yes (KEB)
Over 200% of drive rated current
A
321