YASKAWA V1000 Series Installation & Start-Up Manual page 288

6.5 Drive Replacement
Figure 6.13
Terminal Board (TB) or Control Board (CNT) Replacement
Initialize the drive using
parameter A1-03 = 2220 or 3330
Figure 6.13 Troubleshooting Terminal Board or Control Board Replacement
288
YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)
Troubleshooting Fault Codes at
START
YES
"CPF06" Fault is
displayed upon drive
replacement
NO
Fault "oPE01"
Fault "oPE04"
Ready
END
Note: Drive kVA Setting o2-04 = "FF"
inside a new Terminal Board
YES
NO
Set parameter o2-04 to match drive
YES
NO
Fault "oPE04" drive parameter settings need
to be initialized or uploaded from the TB
Set value = 2220
or 3330
Parameter setting values
nameplate rating
Initialize the drive using
parameter A1-03
Set value = 5550
are copied
TB to CNT