YASKAWA V1000 Series Installation & Start-Up Manual page 336

B.2 Parameter Table
No. Name
Local/Remote Run
b1-07
Selection
Run Command
b1-08 Selection while in
Programming Mode
b1-14 Phase Order Selection
Frequency
b1-15
Reference 2
Run Command Source
b1-16
2
Run Command at
b1-17
Power Up
336
YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)
Description
Determines how the drive will interlock when
the source of the run command switches from
LOCAL to REMOTE. Note that one of the H1
parameters be set to 2 in order to use this
function.
0: Cycle External RUN - If the run command is
closed when switching from local mode to
remote mode, the drive will not run. The run
command must first be shut off and then
entered again in order to operate the motor.
1: Accept External Run - If the run command is
closed when switching from local mode to
remote mode, the drive will run.
0: Disabled - Run command accepted only in
the operation menu.
1: Enabled - Run command accepted in all
menus.
Sets the phase order for drive output terminals
U/T1, V/T2 and W/T3.
0: Standard
1: Switch phase order
Selects the frequency reference input source.
0: Operator - Digital preset speed U1-01 or
d1-01 to d1-17.
1: Terminals - Analog input terminal A1 (or
terminal A2 based on parameter H3-09).
2: Serial Com - Modbus RS-422/485 terminals
R+, R-, S+ and S-.
3: Option PCB
4: Pulse Input (Terminal RP)
Selects the run command input source.
0: Operator - RUN and STOP keys on the
digital operator.
1: Terminals - Contact closure on terminals S1
or S2.
2: Serial Com - Modbus RS-422/485 terminals
R+, R-, S+ and S-.
3: Option PCB
Configures the run command at drive
power-up.
0: No run command issued at power up
1: Run command given when power is switched
on
Control
Mode
Range Def.
V/f O P
LV M
0,1 0 A A A 186
0 to 2 0 A A A 187
0,1 0 A A A 1C3
0 to 4 0 A A A 1C4
0 to 3 0 A A A 1C5
0,1 0 A A A 1C6
Addr. Pg.
Hex
—
—
—
—
—
—