YASKAWA V1000 Series Installation & Start-Up Manual page 376

B.2 Parameter Table
H2-
Function
Setting
Watt Hour Pulse
39
Output
3C Drive Mode
3D Speed Search
3E PID Feedback Loss
3F PID Feedback Fault
4A KEB Operation
4B Short-Circuit Brake
4C During Fast-stop
OH Pre-alarm Time
4D
Limit
DriveWorksEZ Digital
90 to 92
Outputs 1 thru 3
H2 Parameter
100 to Functions Reversed
192 Output Switching of 0
to 92
376
YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)
H2 Multi-Function Digital Output Settings
Output units are determined by H2-06, outputs 200 ms pulse for
each incremented kWh count.
Closed: Local
Open: Remote
(this signal combines setting values 9 and A).
Closed: Speed search is being executed.
Closed: PID Feedback Loss.
PID feedback value (pulse or analog input) is below the level set to
b5-13 for longer than the time set in b5-14.
Closed: PID Feedback Fault.
PID feedback value (pulse or analog input) exceeds the level set to
b5-36 for longer than the time set to b5-37.
Closed: KEB is being performed.
Closed: The Short-Circuit Brake is active.
Closed: A Fast-stop command is entered from the operator or from
the terminals.
Closed: OH Pre-alarm time limit is passed.
–
Reverse the output switching of the multi-function output
functions. Set the last two digits of 1
signal of that specific function.
Examples:
Setting "108" reverses the output of "During baseblock," which is
setting value 08.
Setting "14A" reverses the output of "During KEB operation",
which is setting "4A".
Description
to reverse the output
Control
Mode
Pg.
O
V/ P
L
f M
V
O O O —
O O O —
O O O —
O O O —
O O O —
O O O —
− − O —
O O O —
O O O —
O O O —
O O O —