YASKAWA V1000 Series Installation & Start-Up Manual page 403

No. Name
Copy Function
o3-01
Selection
Copy Allowed
o3-02
Selection
o3-03 Copy Mode Selection
Accumulated
o4-01 Operation Time
Setting
Accumulated
o4-02 Operation Time
Selection
Cooling Fan
o4-03 Maintenance Setting
(Operation Time)
Capacitor
o4-05
Maintenance Setting
YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)
Description
o3: Copy Function
Use o3 parameters to configure copy function operation.
This parameter controls the copying of
parameters to and from the digital operator.
0: COPY SELECT (no function)
1: INV --> OP READ - All parameters are
copied from the drive to the digital operator.
2: OP --> INV WRITE - All parameters are
copied from the digital operator to the drive.
3: OP<-->INV VERIFY - Parameter settings in
the drive are compared to those in the digital
operator.
Note: When using the copy function, the drive
model number (o2-04), software number
(U1-14), and control method (A1-02) must
match or an error will occur.
Enables and disables the digital operator copy
functions.
0: Disabled - No digital operator copy
functions are allowed.
1: Enabled - Copying allowed.
Allows data to be copied that has been
changed.
o4: Maintenance Period
Use o4 parameters to perform maintenance.
Sets the starting value for the cumulative
operation time of the drive.
Sets this parameter to log the cumulative
operation time (U4-01).
0: Logs operation time from power-on (stops
counting when the power supply is
interrupted).
1: Logs operation time from the point the run
command is issued (tracks the operation time
as long as there is drive output).
Resets U4-04 (Cooling Fan Maintenance) to 0.
Resets the capacitor maintenance time
(U4-05).
B.2 Parameter Table
Control
Mode
Range Def. Addr.
O
V/ P
Hex
L
f M
V
0 to 3 0 A A A 515
0,1 0 A A A 516
- - A A A 51A
0 to
0H A A A 50B
65535
0 to 1 0 A A A 50C
0 to
0H A A A 50E
65535
0 to 150 0% A A A 51D
Pg.
—
—
—
B
—
—
—
—
403