3.5 Protective Covers
3.5
Protective Covers
Follow the procedure below to remove the protective covers before wiring the drive and to reattach the covers after wiring is
complete.
u
IP20/Open-Chassis Cover Removal and Installation
n
Removing the Protective Covers
1.
Loosen the screw that locks the front cover in place to remove.
2.
Apply pressure to the tabs on each side of the terminal cover. Pull the terminal cover away from the drive while pushing
in on the tabs to pull the cover free.
n
Reattaching the Protective Covers
Properly connect all wiring and route power wiring away from control signal wiring. Reattach all protective covers when
wiring is complete. Apply only a small amount of pressure to lock the cover back into place.
38
Figure 3.6 Remove the Front Cover on an IP20/Open-Chassis Drive
Figure 3.7 Remove the Terminal Cover on an IP20/Open-Chassis Drive
Figure 3.8 Reattach the Protective Covers on an IP20/Open-Chassis Drive
http://nicontrols.com
YASKAWA ELECTRIC SIEP C710606 31B YASKAWA AC Drive – J1000 Technical Manual