YASKAWA V1000 Series Installation & Start-Up Manual page 140

4.4 Basic Parameter Adjustments
Coast to Stop with Timer (b1-03 = 3)
■
When b1-03 = 3, a stop command will interrupt drive output and the motor will
coast to stop. The drive will not accept the next run command until time t has
passed. Time t is determined by the output frequency at the moment the stop
command was entered and the deceleration time set to the drive according to
Figure 4.20.
Figure 4.20
Run Command
Output Frequency
Drive output voltage interrupted
Operation wait time t
Deceleration time
(C1-02, etc.)
Minimum
Baseblock Time
L2-03
Minimum Output Frequency
140
YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)
ON
Figure 4.20 Coast to Stop with Timer
OFF ON
Operation Wait Time t
Output frequency when
stop command was entered
100
(Max Output Frequency)
OFF ON