Protective Covers; Removing The Protective Covers; Reattaching The Protective Covers - YASKAWA V1000 Series Installation & Start-Up Manual

3.5 Protective Covers

3.5 Protective Covers
Follow the procedure below to remove the protective covers before wiring the drive and to
reattach the covers after wiring is complete.
◆
IP20/Open-Chassis

Removing the Protective Covers

■
1.
Loosen the screw that locks the front cover in place to remove.
Figure 3.10
Figure 3.10 Remove the Front Cover on an IP20/Open-Chassis Drive
2.
Apply pressure to the tabs on each side of the terminal cover. Pull the terminal cover
away from the drive while pushing in on the tabs to pull the cover free.
Figure 3.11
Figure 3.11 Remove the Terminal Cover on an IP20/Open-Chassis Drive

Reattaching the Protective Covers

■
Properly connect all wiring and route power wiring away from control signal wiring.
Reattach all protective covers when wiring is complete. Apply only a small amount of
pressure to lock the cover back into place.
62 YASKAWA ELECTRIC TOEP C710606 09B YASKAWA AC Drive V1000 Installation & Start-Up Manual