YASKAWA V1000 Series Installation & Start-Up Manual page 180

4.5 Test Run
10. Press to stop the drive. The RUN light will flash until the
STOP
motor comes to a complete stop.
When the frequency reference is assigned to the LED operator (b1-01), the first step in a multi-step speed
<1>
sequence comes from d1-01.
Set H3-09 to a value other than 2.
<2>
Note: The procedure can also be completed in REMOTE mode. In this case the run
command must be set at the source set in b1-02.
Note: 1. When b1-01 = 0 and the run command is given, the drive uses the frequency set to d1-01.
2. When b1-01 = 1 and the run command is given, the drive uses the frequency reference
value input to analog control terminal A1.
180
YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)
Step Display/Result
⇒
STOP