Installing Multiple Drives; Removing And Attaching The Protective Covers - YASKAWA V1000 Series Installation & Start-Up Manual

◆

Installing Multiple Drives

When installing multiple drives into the same enclosure panel, allow for the space
as described in Figure
Figure 2.3
A
B
2 mm
A – Line up the tops of the drives.
B – 30 mm minimum
Figure 2.3 Space Between Drives (Side-by-Side Setup)
Note: When installing drives of different sizes into the same enclosure panel, the tops of
the drives should line up. Leave space between the top and bottom of stacked drives
for cooling fan replacement if required. Using this method, it is possible to replace
the cooling fans later.
Note: For this installation type, drive derating must be considered. Set parameter L8-35
accordingly.
◆

Removing and Attaching the Protective Covers

Refer to Electrical Installation on page
and reattachment of protective covers.
YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)
2.3.
Refer to L8-35 on page 395
2.2 Mechanical Installation
B
C
C
C – 100 mm minimum
D – Airflow direction
.
51, for information regarding the removal
2
D
41