Nema Type 1 - YASKAWA V1000 Series Installation & Start-Up Manual

Reattaching the Protective Covers
■
Properly connect all wiring and route power wiring away from control signal
wiring. Reattach all protective covers when wiring is complete. Apply only a small
amount of pressure to lock the cover back into place.
Figure 3.10
Figure 3.10 Reattach the Protective Covers on an Open-Chassis Drive
◆

NEMA Type 1

Removing the Protective Covers on an IP20/NEMA Type 1 design
■
1.
Loosen the screw that locks the front cover in place to remove the front
cover.
Figure 3.11
Figure 3.11 Remove the Front Cover on an IP20/NEMA Type 1 Drive
YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)
3.5 Protective Covers
3
65