Table of Contents
Advertisement
Main Menu
Steering Wheel
Removal
Airbag Removal
Store a removed airbag assembly with the
pad surface up. If the airbag is improperly stored face
down, accidental deployment could propel the unit with
enough force to cause serious injury.
NOTE: Before removing the steering wheel, make sure
the front wheels are straight ahead.
SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS
(section
24) before performing repairs or ser-
vice.
1.
Disconnect both the negative cable and positive
cable from the battery.
2.
Remove the access panel from the steering wheel
lower cover, then remove the short connector.
3.
Disconnect the connector between the airbag and
cable reel.
4.
Connect the short connector to the airbag 3P con-
nector.
Table of Contents
5.
Remove the Torx bolts using a Torx T30 bit, then
remove the driver's airbag assembly.
Advertisement
Chapters
Table of Contents
