Honda NSX-T 1998 Manual page 708

Main Menu
Transmission Assembly
Installation (cont'd)
12. Install a new set ring on the end of the left driveshaft and intermediate shaft.
13. Install the left driveshaft (see
14. Install the lower control arm to the side beam (see
ing cam and lower control arm.
15. Install the damper fork bolt (see
16. Install the toe control arm to the side beam (see
are aligned.
17. Install the wheel sensor wire clamp and parking brake cable holder.
18. Install the intermediate shaft, and tighten the intermediate shaft mounting bolts to the intermediate shaft support
base.
19. Install the intermediate shaft heat cover.
Table of Contents
section 16).
section
section 18).
section
18). Align the reference marks on the adjusting bolt, adjust-
18). Make sure that the arrow marks on the toe control arm