Intake Manifold/Exhaust System - Honda NSX-T 1998 Manual

Main Menu
Intake Manifold
Replacement
NOTE: Use new O-rings and gaskets when reassembling.
CAUTION:
• Check for folds or scratches on the surface of the gasket.
• Replace with a new gasket if damaged.
5 x 1.0 mm
8 N-m (0.8 kgf-m, 6 Ibf-ft)
INTAKE AIR TEMPERATURE
(IAT) SENSOR
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
IGNITION CONTROL
MODULE (ICM)
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
8 x 1.25 mm
22 N-m (2.2 kgf-m,
16 Ibf-ft)
THROTTLE
BODY
8 x 1.25 mm
22 N-m (2.2 kgf-m
16 Ibf-ft)
EGR PIPE
Table of Contents
6 x 1.0 mm
12 N-m (1.2 kgf-m, 8.7 Ibf-ft)
O-RING
Replace.
INSULATOR
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
GASKETS
Replace.
INTAKE MANIFOLD
PLATE
6 x 1.0 mm
12 N-m (1.2 kgf-m, 8.7 Ibf-ft)
EXHAUST GAS RECIRCULATION
(EGR) PORT
8 x 1.25 mm
22 N-m (2.2 kgf-m, 16 Ibf-ft)
GASKET
Replace.
INTAKE MANIFOLD
Replace if cracked or
GASKET
if mating surfaces are
Replace.
damaged.
INTAKE AIR BYPASS (IAB)
VALVE BODY
GASKET
Replace.
INTAKE MANIFOLD
CHAMBER
WASHER
Replace.
8 x 1.25 mm
22 N-m (2.2 kgf-m, 16 Ibf-ft)