Main Menu
Power Door Locks
Control Unit Input Test
Remove the glove box, then disconnect the 18P con-
nector from the control unit.
Inspect the connector terminals to be sure they are all
making good contact.
If the terminals are bent, loose, or corroded, repair
them as necessary, and recheck the system.
If the terminals look OK, make the following input
tests at the connector.
— If any test indicates a problem, find and correct
the cause, then recheck the system.
— If all the input tests prove OK, the control unit
must be faulty; replace it.
Table of Contents
POWER DOOR LOCK
CONTROL UNIT