Honda NSX-T 1998 Manual page 1161

Main Menu
FRONT PILLAR
SEAL
BUTYL TAPE
SEPARATOR
PLASTIC
SPATULA
RETAINER
18. Carefully pull the separator away from the butyl
tape at the roof portion of the front pillar seal.
SEPARATOR
BUTYL TAPE
Table of Contents
BUTYL TAPE
SEPARATOR
LIP
FRONT PILLAR
SEAL
19. Press on the roof portion of the butyl tape to make
the adhesive stick.
NOTE: Do not press on the front pillar seal portion
of the seal yet.
BUTYL TAPE
20. Scrap or wipe the excess sealant off with a putty
knife or towel.
NOTE: To remove sealant from a painted surface or
the front pillar seal, wipe with a soft shop towel damp-
ened with alcohol.
21. Close the doors, then check that there is about 20 mm
(0.79 in) between the top edge of the front sash and
the seam on the front pillar seal on each side.
Adjust the seal as needed, then press on the front
pillar portion of the butyl tape to make the adhesive
stick.
NOTE: Do not raise the door glass.
FRONT SASH
FRONT PILLAR
SEAL
SEAM
FRONT PILLAR
SEAL