Honda NSX-T 1998 Manual page 1114

Main Menu
Replacement
SRS components are located in this area. Review the SRS
component locations, precautions, and procedures in the
SRS (section 24) before performing repairs or service.
1. To remove the dashboard, first remove the:
Seats (see page 20-39)
Dashboard lower cover (Driver's) (see page
20-54)
Dashboard lower pad (see page 20-54)
Dashboard brace (see page 20-54)
Center armrest (see page 20-49)
Clock, center air vent and console panel (see
pages 20-50, 20-51, 20-52)
• Climate control unit and stereo cassette/radio (see
page 20-53)
• Dashboard lower cover (Passenger's) (see page
20-53)
• Glove box lid and glove box (see page 20-53)
2. Lower the steering column (see
To avoid accidental deployment and
possible injury always install the short connector
on the airbag connector when the SRS wire
harness is disconnected.
Table of Contents
section 17).
NOTE:
• Remove the access panel, then remove the
short connector (RED). Disconnect the connec-
tor between the airbag and cable reel, then con-
nect the short connector (RED) to the airbag
connector.
AIRBAG
CONNECTOR
ACCESS PANEL
• Connect the special tool to the cable reel
connector.
SHORT
CONNECTOR
(RED)
SRS
SERVICE CONNECTOR
07MAZ-SP00200
CABLE REEL
CONNECTOR
SHORT CONNECTOR
(RED)
CABLE REEL
CONNECTOR