Honda NSX-T 1998 Manual page 1088

Main Menu
1 3. With a sponge, apply a light coat of glass primer
around the edge of the rear window as shown, then
lightly wipe it off with gauze or cheesecloth.
NOTE:
• Do not apply body primer to the rear window,
and do not get body and glass primer sponges
mixed up.
• Never touch the primed surfaces with your
hands. If you do, the adhesive may not bond to
the inner glass properly, causing a leak after the
rear window is installed.
• Keep water, dust, and abrasive materials away
from the primed surface.
Upper Molding Section
INNER
GLASS
UPPER MOLDING
14. With a sponge, apply a light coat of body primer to
the original adhesive remaining around the rear
window opening flange.
NOTE:
• Do not apply body primer to the rear window,
and do not get body and glass primer sponges
mixed up.
• Never touch the primed surfaces with your
hands.
Apply body primer here.
Table of Contents
Apply glass primer here.
Lower Molding Section
LOWER
INNER
MOLDING
GLASS
15. Thoroughly mix the
together on a glass or metal plate with a putty
knife.
NOTE:
• Clean the plate with a sponge and alcohol before
mixing.
• Follow the instructions that came with the
adhesive.
16. Before filling a cartridge, cut the end of the nozzle
as shown.
Cut nozzle
end as shown.
17. Pack adhesive into the cartridge without air
pockets to ensure continuous delivery. Put the car-
tridge in a calking gun, and run a bead of adhesive
around the edge of the rear window as shown.
NOTE: Apply the adhesive within thirty minutes
after applying the glass primer.
4 mm (0.2 in)
13 mm ADHESIVE
(0.5 in)
8 mm (0.3 in)
REAR WINDOW
ADHESIVE
ADHESIVE
Make a slightly
thicker bead at
each corner.
adhesive and hardener
10 mm (0.39 in)
7 mm (0.3 in)
ADHESIVE
INNER
GLASS
INNER GLASS