Honda NSX-T 1998 Manual page 509

Main Menu
Oil Pump
Removal/lnspection/lnstallation (cont'd)
23. Install the oil pump on the cylinder block.
24. Install the oil pass pipe and joint.
25. Install the baffle plate.
26. Install the oil screen.
SPECIAL BOLTS
SPECIAL BOLTS
6 x 1.0 mm
8 x 1.25 mm
12 N-m (1.2 kgf-m, 8.7 Ibf-ft)
22 N-m (2.2 kgf-m,
Replace.
16 Ibf-ft)
Replace.
OIL PUMP
Apply liquid gasket to
cylinder block mating
surface.
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
OIL
SCREEN
Table of Contents
DOWEL PINS
OIL PASS
PIPE AND JOINT
BAFFLE
PLATE
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
27. Apply liquid gasket to the oil pump and left side
cover mating areas as shown below.
Apply liquid gasket
to these points.
OIL PUMP
Apply liquid gasket
to these points.
28. Install the oil pan gasket and oil pan.
NOTE: Use a new oil pan gasket.
LEFT
SIDE
COVER
CYLINDER
BLOCK
GASKET
Replace.
OIL PAN