Honda NSX-T 1998 Manual page 695

Main Menu
Synchro Ring, Gear
Inspection
1. Inspection the synchro ring and gear.
A : Inspect the inside of the synchro ring for wear.
B : Inspect the synchro sleeve teeth and matching
teeth on the synchro ring for wear (rounded off).
C : Inspect the synchro sleeve teeth and matching
teeth on the gear for wear (rounded off).
D : Inspect the gear hub thrust surface for wear.
E : Inspect the cone surface for wear and rough-
ness.
F : Inspect the teeth on all gears for uneven wear,
scoring, gaining, and cracks.
2. Coat the cone surface of the gear with oil, and place
the synchro ring on the matching gear. Rotate the
synchro ring, making sure that it does not slip.
Measure the clearance between the synchro ring
and gear all the way around. Hold the synchro ring
against the gear evenly while measuring the clear-
ance.
If the clearance is less than the service limit, replace
the synchro ring and synchro cone.
Table of Contents