Honda NSX-T 1998 Manual page 445

Main Menu
Cylinder Heads
Removal (cont'd)
26. Remove the engine wire harness connectors and
wire harness clamps from the cylinder head and
intake manifold.
• Six injector connectors
• Intake air temperature (IAT) sensor connector
• CKP/CYP sensor connector
• Heated oxygen sensor (HO2S) connectors
• Ignition control module (ICM) connectors
• Engine coolant temperature (ECT) sensor connec-
tor
• Coolant temperature gauge sending unit connec-
tor
• Radiator fan control sensor connector
• Exhaust gas recirculation (EGR) valve lift sensor
connector
• Throttle position sensor connector
• Engine oil pressure gauge sending unit connector
• Knock sensor connector
• VTEC solenoid valve connectors
• VTEC pressure switch connectors
• Engine oil pressure switch connector
• Alternator connector
• Alternator terminal
• Throttle body 6P connector
27. Remove the ignition coils and connector.
28. Remove the EGR pipe and intake manifold assem-
bly.
GASKETS
Replace.
Table of Contents
INTAKE
MANIFOLD
ASSEMBLY
GASKET
Replace.
29. Loosen the adjusting nut and idler pulley center nut,
then remove the air conditioning compressor belt
(see page 6-17).
30. Remove the cover, adjusting bolt, mounting bolt
and mounting nut, then remove the alternator belt
and alternator.
ADJUSTING
BOLT
MOUNTING NUT
31. Disconnect the knock sensor connector, then remove
the wire holder.
COVER
MOUNTING BOLT
ALTERNATOR
BELT
KNOCK SENSOR
WIRE HOLDER