Honda NSX-T 1998 Manual page 1319

Main Menu
A/T Gear Position Switch
Replacement
SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS section 24 before performing repairs or ser-
vice.
1. Remove the center console panel and dashboard
(see section 20).
2. Disconnect the 12P and 2P connectors from the A/T
gear position switch.
SWITCH SLIDER (In
A/T GEAR POSITION SWITCH
3. Remove the two position switch mounting bolts.
4. Position the slider on the new switch to
above.
5. Shift the shift lever to
position.
6. Attach the switch with the two bolts.
7. Test the switch in the
should be able to start the engine with the shift
lever in position
play.
8. Connect the 12P and 2P connectors, clamp the har-
ness, and install the dashboard and center console
panel.
Table of Contents
|
as shown
, then slip the switch into
and positions. You
anywhere in the range of free
Bulb Replacement
SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS section 24 before performing repairs or ser-
vice.
1. Remove the gauge assembly (see page 23-126).
2. Disassemble the gauge assembly (see page 23-129).
3. Remove the bulb from printed circuit board B.
4. Install the indicator in the reverse order of removal.
PRINTED CIRCUIT
BOARD B
BULB (1.12 W)