Honda NSX-T 1998 Manual page 1104

Main Menu
Inspection
SRS wire harnesses are routed near the retractor.
All SRS wire harnesses and connec-
tors are colored yellow. Do not use electrical test
equipment on these circuits.
CAUTION:
• Be careful not to damage the SRS wire har-
nesses when servicing the retractor.
• Remove the short connector (RED) from the its
holder and disconnect the SRS wire harness
connector, then connect the short connector
(RED) to the tensioner connector.
NOTE: To keep out dust, wrap the SRS wire har-
ness connector with a protective cover.
RETRACTOR
SEAT BELT
TENSIONER
PROTECTIVE
COVER
SRS WIRE
HARNESS
SRS WIRE HARNESS
CONNECTOR
Retractor Inspection
CAUTION: When checking the retractor, do not
touch the seat belt tensioner.
1. Before installing the retractor, check that the seat
belt can be pulled out freely.
2. Make sure that the seat belt does not lock when the
retractor is leaned slowly up to 15° from the
mounted position. The seat belt should lock when
the retractor is leaned over 40°.
CAUTION: Do not attempt to disassemble the
Table of Contents
TENSIONER
CONNECTOR
CONNECTOR
HOLDER
SHORT
CONNECTOR
(RED)
3. Replace the seat belt with a new one if there is any
abnormality.
On-the-Car Seat Belt Inspection
1. Check that the seat belt is not twisted or caught on
anything.
2. After installing an anchors, check for free move-
ment on its retaining bolt. If necessary, remove the
bolt and check that the washers and other parts are
not damaged or improperly installed.
3. Check the seat belts for damage or discoloration.
Clean with a shop towel if necessary.
CAUTION: Use only soap and water to clean.
NOTE: Dirt built-up in the metal loops of the seat
belt anchors can cause the seat belts to retract
slowly. Wipe the inside of the loops with a clean
cloth dampened in isopropyl alcohol.
4. Check that the seat belt does not lock when pulled
out slowly. The seat belt is designed to lock only
during a sudden stop or impact.
5. Make sure that the
automatically when released.
6. Replace the seat belt with a new one if there is any
abnormality.
seat belt will retract