Honda NSX-T 1998 Manual page 1142

Main Menu
4. Remove the bonded portion of the roof side seal
from one end, then pull the seal away from the roof
side retainer, and remove the bonded portion from
the other end.
NOTE:
• If the old roof side seal is to be reinstalled, take
care not to damage it.
• If the roof side seal is damaged, replace it with
new one.
• When removing the bonded portions of each
roof side seal, remove them gradually.
Rear:
ROOF SIDE
RETAINER
Front:
ROOF SIDE
SEAL
Table of Contents
ROOF SIDE
SEAL
BONDED
PORTION
BONDED
PORTION
5. Remove the screws, then remove the roof side
retainer.
Screw locations, 3
6. Scrape the old sealant and EPT sealer from the roof
bonding surfaces with a putty knife.
NOTE: Do not scrape down to the painted surfaces
of the roof.
7. Clean the roof bonding surfaces with a sponge
dampened in alcohol.
NOTE: After cleaning, keep oil, grease and water
from getting on the surface.
8. If the old roof side retainer is to be reinstalled, use a
putty knife to scrape off all traces of old sealant and
the EPT sealer, then clean the roof side retainer sur-
face with alcohol where new sealant and EPT sealer
are to be applied.
ROOF SIDE
RETAINER
ROOF SIDE
RETAINER