Main Menu
Ignition Switch
Test
1.
Remove the dashboard lower cover (see next
column).
2.
Disconnect the 7P connector from the floor wire
harness.
3.
Check for continuity between the terminals in each
switch position according to the table.
WHT (IG2-A)
WHT (BAT-A)
BLU/WHT (IG2-B)
WHT/RED (ACC)
Table of Contents
7P CONNECTOR
BLK/YEL (IG1)
View from
wire side
BLK/WHT 1ST)
WHT/BLK (BAT-B)
Electrical Switch Replacement
1.
Remove the dashboard lower cover, and disconnect
the floor wire harness connectors.
2.
Disconnect the 7P connector from the floor wire
harness.
3.
Insert the key, and turn it to "0".
4.
Remove the two screws, and replace the switch.
SWITCH
DASHBOARD
LOWER
COVER
LOCK CYLINDER