Honda NSX-T 1998 Manual page 948

Main Menu
Hub Replacement
NOTE:
• Use only genuine Honda wheel weights for aluminum wheels. Non-genuine wheel weights may corrode and damage
the aluminum wheels.
• On the aluminum wheels, remove the center cap from inside of the wheel after removing the wheel.
• Before installing the brake disc, clean the mating surface of the front hub and inside of the brake disc.
• Before installing the wheel, clean the mating surfaces of the brake disc and inside of the wheel.
Corrosion resistant bolt/nut
SELF-LOCKING NUT
10 x 1.25 mm
Replace.
64 N-m (6.5 kgf-m, 47 Ibf-ft)
KNUCKLE
BRAKE DISC
Check for wear and rust.
Inspection, section
FLAT HEAD SCREW
6 x 1.0 mm
9.8 N-m (1.0 kgf-m, 7 Ibf-ft)
Table of Contents
SPLASH GUARD
19.
SPINDLE NUT
26 x 1.5 mm
Replace.
329 N-m (33.5 kgf-m, 242 Ibf-ft)
NOTE: After tightening, use a drift to
stake the spindle nut shoulder against
the spindle.
HUB BEARING ASSEMBLY
Inspect for faulty
movement and wear.
Replacement, page
PULSER
CENTER CAP
18-17
FRONT HUB
Check for damage and
cracks.
Replacement,
page 18-17
WHEEL NUT
12 x 1.5 mm
108 N-m (11 kgf-m, 80 Ibf-ft)