Table of Contents
Advertisement
Main Menu
Trunk Light Test/Replacement
NOTE: The bulb or lens alone can be replaced without
having to remove the trunk side panel.
1.
Remove the trunk side panel.
2.
Disconnect the 3P connector from the light housing.
3.
Remove the two screws and the retainer plate, then
remove the light from the trunk side panel.
BULB (3.4W)
LENS
HOUSING
4.
Make sure that the bulb is OK, then check for con-
tinuity between the A and B terminals. There should
be continuity.
NOTE: This light has a built-in diode. To get an ac-
curate reading, either test it with a volt-ohmmeter
that compensates for diodes, or make sure you con-
nect your test leads to match the polarity shown.
From No.34 (15A) FUSE
To LATCH SWITCH
Table of Contents
TRUNK SIDE
PANEL
RETAINER
PLATE
A
Latch Switch Test/Replacement
1.
Open the trunk lid, and remove the trunk rear panel.
2.
Disconnect the trunk latch 3P connector.
LOCK ROD.
View from wire side
3.
Check for continuity between the A terminal and
body ground with the latch open. There should be
continuity.
4.
If you need to remove the latch, disconnect the lock
rod from the latch, then remove the two bolts, and
pull the latch toward the left side.
5.
Disconnect the trunk opener cable from the latch.
TRUNK LATCH
TRUNK OPENER
CABLE
3P CONNECTOR
Advertisement
Chapters
Table of Contents
