Table of Contents
Advertisement
Main Menu
Preset Torque
Inspection
On-Vehicle:
1.
Lift up right rear wheel, and place the safety stand.
(Lift and Support Points, see
2.
Block the other three wheels.
3.
Measure preset torque clockwise using a torque
wrench as shown.
Standard:
59 - 137 N-m
(6 - 14 kgf-m, 43 - 101 Ibf-ft)
Service Limit: 29 N-m (3 kgf-m, 22 Ibf-ft)
TORQUE WRENCH
RIGHT REAR WHEEL
4.
If preset torque is less than the service limit, replace
the clutch discs with new ones. Adjust the thrust
shim whenever the clutch discs are replaced (see
page 15-22).
Table of Contents
section
1).
SAFETY STAND
Assembly:
Place one special tool in a vise. Place the left side of
the differential assembly on the special tool, then
preset the differential with 3 — 5 rotations, both
clockwise and counterclockwise.
2.
Measure preset torque clockwise using a torque
wrench as shown.
Standard:
59 - 137 N-m
(6 - 14 kgf-m, 43-101 Ibf-ft)
Service Limit: 29 N-m (3 kgf-m, 22 Ibf-ft)
TORQUE WRENCH
3.
If preset torque is less than the service limit, replace
the clutch discs with new ones. Adjust the thrust
shim whenever the clutch discs are replaced (see
page 15-22).
DIFFERENTIAL
INSPECTION TOOLS
07MAJ - PR90100
DIFFERENTIAL
INSPECTION TOOLS
07MAJ - PR90100
Advertisement
Chapters
Table of Contents
