Table of Contents
Advertisement
Main Menu
Thickness and Parallelism
Inspection
1.
Raise each side of the vehicle, and support it on
safety stands (see page
front wheels.
2.
Remove the brake disc pads (see page 19-7).
3.
Using a micrometer, measure disc thickness at
eight points, approximately 45° apart and 10 mm
(0.4 in) in from the outer edge of the disc.
Brake disc thickness:
Standard:
28.0 mm (1.10 in) max.
Service Limit: 26.0 mm (1.02 in)
Brake Disc Parallelism:
The difference between any thickness measure-
ments should not be more than 0.015 mm (0.0006
in).
4.
If the disc is beyond the limits for parallelism, refin-
ish it.
Max. Refinishing Limit: 26.0 mm (1.02 in)
Table of Contents
1-10
through 1-12). Remove the
Advertisement
Chapters
Table of Contents
