Table of Contents
Advertisement
Main Menu
Rear Caliper
Reassembly (cont'd)
16. Coat the new piston seal and piston boot with sili-
cons grease, and install them in the caliper.
17. Coat the outside of the piston with silicone grease,
and install it on the adjusting bolt while rotating it
clockwise.
CAUTION: Avoid damaging the piston and piston
boot.
Table of Contents
18. Install the brake pad retainers and brake pads.
19. Install the pad spring on the caliper.
20. Install the caliper on the caliper bracket, and tighten
the caliper mounting bolts.
21. Connect the brake hose to the caliper with new seal-
ing washers, and tighten the banjo bolt.
22. Connect the parking brake cable to the arm on the
caliper.
23. Fill the brake reservoir up, and bleed the brake sys-
tem (see page 19-11).
24. Operate the brake pedal several times, then adjust
the parking brake lever.
NOTE: Before adjustments, make sure the parking
brake arm on the caliper touches the pin.
25. Install the caliper shield and tighten the bolts.
Advertisement
Chapters
Table of Contents
