Table of Contents
Advertisement
Main Menu
17. Scrape or wipe the excess sealant off with a putty
knife or towel.
NOTE: To remove sealant from a painted surface or
the roof side seal, wipe with a soft shop towel
dampened with alcohol.
18. Let the roof stand for at least three hours after
installing the roof side seal.
19. Before installing the roof trim, install the roof on the
body, then check that the seal fits flush (see page
20-107).
If necessary, align the roof side seal by adjusting
the roof side lock unit (see page 20-106).
When you are satisfied that the seal fits properly,
press on the seal to make the adhesive stick.
20. Check that the door glass contacts the seal evenly
(see page 20-109).
21. Check for water leaks (see page 20-110).
22. Remove the roof, then install the roof trim (see
page 20-82).
Table of Contents
Advertisement
Chapters
Table of Contents
