Table of Contents
Advertisement
Main Menu
Rocker Arms — Manual Inspection
1.
Remove the ignition coil covers (see page 6-15).
2.
Remove the ignition coils (see page 6-15).
3.
Remove the cylinder head covers.
NOTE: Refer to pages 6-49,
cylinder head cover.
4.
Set the No. 1 piston at top dead center (TDC) (see
page 6-19).
5.
Push the mid rocker arms on the No. 1 cylinder man-
ually.
6.
Check that the mid rocker arms move independently
of the primary and secondary rocker arms.
PRIMARY
ROCKER ARM
7.
Check the mid rocker arms of each cylinder at TDC.
• If a mid rocker arm does not move, remove the
mid, primary and secondary rocker arms as an
assembly and check that the pistons in the mid
and primary rocker arms move smoothly.
• Replace the rocker arms as an assembly if there
is any abnormality.
Table of Contents
6-50
when installing the
MID ROCKER
ARM
SECONDARY
ROCKER ARM
Advertisement
Chapters
Table of Contents
