Honda NSX-T 1998 Manual page 1109

Main Menu
Dashboard
Component Removal/Installation
Clock and center air vent removal:
NOTE: Take care not to scratch the dashboard and
related parts.
1. Remove the clock by pulling it backward from the
center air vent, then disconnect the connector.
2. Remove the center air vent mounting screws.
Disconnect the connector.
CENTER AIR
VENT
3. Insert a plastic between the center air vent and
center console panel to prevent damaging them.
CENTER AIR VENT
CENTER CONSOLE
PANEL
Table of Contents
CLOCK
CENTER AIR VENT
MOUNTING SCREWS
PLASTIC PLATE
(Thin plate)
4. To make a gap between the center air vent and
dashboard, pull the top of the center air vent while
lowering it as shown.
NOTE: Make as large a gap as possible.
DASHBOARD
5. Insert a flat tip screwdriver between the center air
vent and dashboard as shown.
NOTE: Use the correct size flat tip screwdriver as
shown.
3.3 mm (0.13 in)
max.
DASHBOARD
CENTER AIR
VENT
PLASTIC
PLATE
CENTER AIR
VENT
PLASTIC
PLATE
FLAT TIP
SCREWDRIVER