Table of Contents
Advertisement
Main Menu
Ignition Coil Test
1. With the ignition switch OFF, remove the ignition
coil.
2.
Using an ohmmeter, measure resistance between
the terminals. Replace the coil if the resistance is
not within specifications.
NOTE: Resistance
temperature; specification is at 77°F (25°C).
Primary Winding Resistance
(Between the A and B terminals): 0.9 - 1.1 ohms
3.
If primary winding resistance is OK, substitute a
known-good ignition coil, and check the system
operation.
If the system is normal, replace the original ignition
coil.
Table of Contents
will
vary
with
the
coil
A TERMINAL
B TERMINAL
SECONDARY
WINDING
TERMINAL
IGNITION
COIL
SECONDARY
WINDING
TERMINAL
SPARK PLUG
VOLTAGE
SENSOR
Advertisement
Chapters
Table of Contents
