Honda NSX-T 1998 Manual page 1172

Main Menu
16. Check that each roof side lock handle works
smoothly.
17. Remove the roof.
18. If the roof side retainer has not been replaced, and
or the EPT sealer on the roof side retainer has not
been replaced, do the following (see page 20-84):
a. Remove the roof side seal and roof side retainer
from the roof,
b. Replace the EPT sealer on the roof side retainer
and roof.
c. Replace the butyl tapes on the roof side seal,
d. Reinstall the roof side retainer, then apply new
sealant,
e. Reinstall the roof side seal.
19. Check the lips of the roof side seal, and glue the
peeled lip securely with sealant, then wipe the
excess sealant off with a soft shop towel dampened
with alcohol.
20. After applying the sealant, let the roof stand for at
least three hours.
21. Install the roof on the body, then make sure the
seals fit flush.
NOTE: Make sure both roof side lock handles are
locked securely.
22. Check that the door glass contacts the seal evenly
as follows:
a. Raise the door glass fully, and close the door.
Table of Contents
RETAINER
b. Mark a line on the door glass using a thin plastic
plate as shown,
c. Open the door, then check that there is 1 - 3 mm
(0.039 - 0.12 in) between the door glass edge
and the a line around the front pillar and roof,
d. If necessary, adjust the door glass (see page
20-14).
PLASTIC
PLATE
DOOR
SEAL
GLASS
MEASURING AREA
23. Check for water leaks (see page 20-110).
24. Remove the roof, then reinstall all remaining removed
parts.
DOOR
GLASS
DOOR
GLASS