Table of Contents
Advertisement
Main Menu
Manual Valve Detent Spring
Replacement/Adjustment
NOTE: Select the appropriate manual valve detent
spring when these parts are replaced:
• Manual Valve
• Manual Valve Detent Spring
• Manual Valve Lever of Control Shaft
1.
Install the main valve body, including the ATF
pump gears, onto the torque converter housing,
and tighten the main valve body bolts to 12 N-m
(1.2 kgf-m, 8.7 Ibf-ft).
See page 14-161.
2.
Install the control shaft.
3.
Install the manual valve detent spring on the main
valve body and tighten the spring bolt to 14 N-m
(1.4 kgf-m, 10 Ibf-ft).
4.
Set the manual valve to the
5.
Measure the distance between the main valve body
and manual valve as shown.
DISTANCE: 28.0 - 29.0 mm (1.102 - 1.142 in)
6.
If the measurement is out of tolerance, select the
appropriate manual valve detent spring using the
table below, then install it and recheck it.
Table of Contents
position.
Parking Brake Stopper
Inspection/Adjustment
1.
Set the parking brake lever in the
2.
Measure the distance between the face of the park-
ing pawl shaft and face of the parking shift arm roller
pin as shown.
DISTANCE: 52.1-53.1 mm (2.051-2.091 in)
3.
If the measurement is out of tolerance, select and
install the appropriate parking brake stopper from
the table below.
4.
After replacing the parking brake stopper, make
sure the distance is within tolerance.
position.
Advertisement
Chapters
Table of Contents
