Honda NSX-T 1998 Manual page 838

Main Menu
Transmission
Installation (cont'd)
27. Install the three transmission mounting bolts and
the two transmission housing mounting bolts.
28. Install the starter motor, and tighten the starter
motor mounting bolts.
29. Install the ATF cooler.
30. Connect the transmission ground cable, starter motor
cable, solenoid valve wire connectors, and vehicle
speed sensor (VSS) wire connectors.
31. Install the control box, and connect the control box
connectors.
32. Install the air cleaner housing.
33. Install the strut bar.
TORQUE: 38 N-m (3.9 kgf-m, 28 Ibf-ft)
Table of Contents
34. Refill the transmission with ATF.
35. Connect the positive (+) and negative (-) cables to
the battery.
36. Inspect the rear camber (see
37. Start the engine. Set the parking brake, and shift the
transmission through all gears three times. Check for
proper shift cable adjustment.
38. Check the ignition timing (see
39. Let the engine reach normal operating temperature
(the cooling fan comes on) with the transmission in
position, then turn it off and check the fluid
level.
40. Road test as described on page
section 18).
section 23).
14-102 and 14-103.