Table of Contents
Advertisement
Main Menu
Preset Torque
Inspection
On-Vehicle:
1.
Block the front wheels.
2.
Shift to low gear.
3.
Lift up rear wheels, and place the safety stand (Lift
and Support Points, see
4.
Measure preset torque clockwise using a torque
wrench as shown.
Standard:
118 - 275 N-m (12 - 28 kgf m,
87 - 203 Ibf-ft)
Service Limit: 60 N-m (6 kgf-m, 43 Ibf-ft)
TORQUE WRENCH
RIGHT REAR WHEEL
5.
If preset torque is less than the service limit, replace
the limited slip differential clutch set. Adjust the 65
mm (differential housing cover side) and 112 mm
(differential housing cover side) shims whenever
the clutch set is replaced.
Table of Contents
section 1
) .
SAFETY STAND
Assembly:
1.
Place one special tool in a vise. Place the left side
of the differential assembly on the special tool, then
preset the differential with 3 - 5 r o t a t i o n s , counter
clockwise.
2.
Measure preset torque counterclockwise using a tor-
que wrench as shown.
Standard:
59 - 137 N-m (6 - 14 kgf-m,
43 - 101 Ibf-ft)
Service Limit: 30 N-m (3 kgf-m, 22 Ibf-ft)
TORQUE WRENCH
3.
If preset torque is less than the service limit, replace
the limited slip differential clutch set. Adjust the 65
mm and 112 mm shims whenever the clutch set is
replaced.
DIFFERENTIAL
INSPECTION TOOLS
07MAJ- PR90100
DIFFERENTIAL
INSPECTION TOOLS
0 7 M A J - PR90100
Advertisement
Chapters
Table of Contents
