Honda NSX-T 1998 Manual page 497

Main Menu
BEARING CAP
BRIDGE
SIDE BOLT
10
x 1.25 mm
49 N-m (5.0 kgf-m,
36 Ibf-ft)
8. Apply liquid gasket to the block mating surface of
the left side cover and oil pump case, and install
them on the engine block.
NOTE: The seal surface on the block should be
dry. Apply a light coat of oil to the crankshaft and
to the lip of seal.
LEFT SIDE:
Apply liquid
gasket to block
mating surface.
DOWEL PIN
DOWEL PIN
LEFT SIDE COVER
SPECIAL BOLTS
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
Replace.
Table of Contents
CAP BRIDGE BOLT
11 x 1.5 mm
65 N-m (6.6 kgf-m,
BAFFLE PLATE
48 Ibf-ft)
CAP BOLT
9 x 1.25 mm
39 N-m (4.0 kgf-m,
29 Ibf-ft)
OIL PUMP SIDE:
6 x 1.0 mm
12 N-m (1.2 kgf-m, 8.7 Ibf-ft)
OIL PASS
PIPE
OIL PUMP
SPECIAL BOLTS
Apply liquid
6 x 1.0 mm
gasket to block
12 N-m (1.2 kgf-m,
mating surfaces.
8.7 Ibf-ft)
Replace.
NOTE:
• Use liquid gasket. Part No. 08718-0001 or 08718
- 0003.
• Check that the mating surfaces are clean and
dry before applying liquid gasket.
• Apply liquid gasket evenly, being careful to cover
all of the mating surface.
• To prevent leakage of oil, apply liquid gasket to
the inner threads of the bolt holes.
OIL SCREEN
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
SPECIAL BOLTS
8 x 1.25 mm
22 N-m (2.2 kgf-m,
16 Ibf-ft)
Replace.